recover_data_from_failed_netgear_stora_ms2110_nas
Differences
This shows you the differences between two versions of the page.
Next revision | Previous revision | ||
recover_data_from_failed_netgear_stora_ms2110_nas [2018/07/13 21:15] – created juckins | recover_data_from_failed_netgear_stora_ms2110_nas [2018/07/14 17:02] (current) – juckins | ||
---|---|---|---|
Line 1: | Line 1: | ||
==== Recover Data from failed Netgear STORA MS2110 NAS ==== | ==== Recover Data from failed Netgear STORA MS2110 NAS ==== | ||
+ | * The NETGEAR MS2110-1000NAS failed | ||
+ | * It would only power on but disks would not sync | ||
+ | * Attempts to forcefully reset it did not work | ||
+ | Below are the steps used to successfully access the data using 1 of the hard disks. | ||
+ | |||
+ | This STORA appears to use a software RAID configuration and the data is formatted using the Linux XFS file system. | ||
+ | |||
+ | The basic idea is to have a desktop PC running linux, such as 64-bit Red Hat Enterprise Linux 6 (RHEL6) or [[https:// | ||
+ | |||
+ | < | ||
+ | # cat / | ||
+ | Personalities : [raid1] | ||
+ | md127 : active (auto-read-only) raid1 sdb1[0] | ||
+ | 976562432 blocks [2/1] [U_] | ||
+ | | ||
+ | unused devices: < | ||
+ | </ | ||
+ | The result shows what the active RAID1 device is, as seen above it is **md127**. | ||
+ | |||
+ | < | ||
+ | # mdadm --stop /dev/md127 | ||
+ | mdadm: stopped /dev/md127 | ||
+ | </ | ||
+ | This stops the RAID device so you can act upon it. Look for confirmation that it is **stopped**. | ||
+ | |||
+ | < | ||
+ | # mdadm --assemble /dev/md127 --run /dev/sdb1 | ||
+ | mdadm: /dev/md127 has been started with 1 drive (out of 2). | ||
+ | </ | ||
+ | This starts the RAID with 1 drive | ||
+ | |||
+ | < | ||
+ | # mkdir /stora | ||
+ | </ | ||
+ | This creates a local mount point for the STORA drive you are about to access | ||
+ | |||
+ | < | ||
+ | mount /dev/md127 /stora | ||
+ | </ | ||
+ | The NAS hard disk is now accessible in / | ||
+ | |||
+ | < | ||
+ | cd /stora | ||
+ | </ | ||
+ | View the files and copy them to another location, rsync is a good tool for this. |
recover_data_from_failed_netgear_stora_ms2110_nas.1531530932.txt.gz · Last modified: 2018/07/13 21:15 by juckins