install_unifi_on_ubuntu
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
install_unifi_on_ubuntu [2020/10/27 15:29] – juckins | install_unifi_on_ubuntu [2023/01/09 21:16] – juckins | ||
---|---|---|---|
Line 2: | Line 2: | ||
//Follow [[https:// | //Follow [[https:// | ||
- | //Make a copy of the VM first (keep NAT settings to force same IP), shut it down, and use the copy VM as a test.// | + | //<color #ed1c24>Make a copy of the VM first (keep NAT settings to force same IP), shut it down, and use the copy VM as a test.</color>// |
+ | |||
+ | __22 May 2022__ | ||
+ | |||
+ | Updated to version 7.1.65 | ||
+ | |||
+ | __20 Apr 2022__ | ||
+ | |||
+ | Updated to version 7.0.25 | ||
+ | |||
+ | __31 Dec 2021__ | ||
+ | |||
+ | Updated to version 6.5.55 | ||
+ | |||
+ | __10 Oct 2021__ | ||
+ | |||
+ | Updated to version 6.4.54 | ||
+ | |||
+ | __18 Jul 2021__ | ||
+ | |||
+ | Updated to version 6.2.26 | ||
+ | |||
+ | __24 May 2021__ | ||
+ | |||
+ | Updated to version 6.2.25 | ||
+ | |||
+ | __29 Jan 2021__ | ||
+ | |||
+ | Updated to version 6.0.45 | ||
+ | |||
+ | __27 Jan 2021__ | ||
+ | |||
+ | Disk space is running low and / | ||
+ | |||
+ | Then do the following: | ||
+ | |||
+ | sudo service mongodb stop (or find processID and kill it) | ||
+ | sudo rm -rf / | ||
+ | sudo service mongodb start (or reboot) | ||
+ | |||
+ | The WiredTigerLog files in / | ||
+ | |||
+ | Since the test VM still had 100MB journal files, did not do that on the primary VM. | ||
+ | |||
+ | __9 Jan 2021__ | ||
+ | |||
+ | Updated to version 6.0.43 | ||
+ | |||
+ | __6 Dec 2020__ | ||
+ | |||
+ | Updated to version 6.0.41 | ||
+ | |||
+ | __23 Nov 2020__ | ||
+ | |||
+ | Updated to version 6.0.36 | ||
__27 Oct 2020__ | __27 Oct 2020__ | ||
Line 133: | Line 187: | ||
</ | </ | ||
Then login to the controller and adopt the AP. | Then login to the controller and adopt the AP. | ||
+ | |||
+ | NOTE: If the controller won't adopt, you may have to factory reset it by logging via ssh and issuing hte command ' | ||
Always follow the instructions when you ssh into the AP...you may need to run the " | Always follow the instructions when you ssh into the AP...you may need to run the " | ||
Line 141: | Line 197: | ||
* [[https:// | * [[https:// | ||
* To get to the AP properties which list the radio channels and power output, click on " | * To get to the AP properties which list the radio channels and power output, click on " | ||
+ | |||
+ | this '' |
install_unifi_on_ubuntu.txt · Last modified: 2023/01/09 21:17 by juckins